SkullandBonesSkateboards.com Forum Index » MANUFACTURERS FORUM » Skateboard Press - Any Suggestions? |
Page 3 of 3 Goto page Previous 1, 2, 3 |
|
Author |
Message |
Everide |
Posted: Sun Jun 04, 2006 8:31 pm |
|
|
Joined: 16 Apr 2006
Posts: 81
Location: MidWest
|
I like that turbo enerpac. That would make for a sweet setup.
I was looking at a 6" stroke for the cylinder(50ton). Then I thought it wouldn't be much harder to make something similar to what snowboardmaterials had in there used section: http://snowboardmaterials.com/pages/used_skate.htm
Its a doubled up mold. I would just need a longer stroke.. I was thinking a 14" would be sufficient.
Any problems you guys can see with doing that? It would press the decks with the same amount of pressure, but you would be able to do twice as many at a time. And if thats the case.....maybe you could do three molds when you got the hang of it?
Josh |
|
|
Back to top |
|
|
yoinigo |
Posted: Mon Jun 12, 2006 7:59 pm |
|
|
Joined: 24 May 2006
Posts: 7
|
are there any ways to make decks that costes around 610 bucks thats all i got |
_________________ i skate live it at that |
|
Back to top |
|
|